Total item
Cart Subtotal
Rs 0.00 Details
Description
Top quality water emulsion, pigmented with light fast, alkali resistant pigments and containing a mould control additive. It provides pleasing uniformity of color and due to low reflectance, it hides surface imperfections.
Recommended Usage
Suitable for protection and decoration of all the usual exterior masonry surfaces such as brick, concrete, cement rendering, pebble dash and similar surfaces, unpainted or pre-painted. It is particularly suitable where alkali resistance and exterior durability are the prime requirements. It can also be used for interior protection and decorations.
COMPOSITION
Based on copolymer emulsion binder & light fast pigments free from toxic metals.
MIXING RATIO
Single pack, ready to use after thinning with water.
COVERAGE
13-14 m2 per liter per coat on non porous surfaces
ODOR
Odorless / VOC bee
FILM THICKNESS
20 to 25 microns per coat
THINNER
Water
FLASH POINT
Not Applicable
PROCESS & APPLICATION
SURFACE PREPARATION
Ensure that the surface is thoroughly dry, clean and sound. Repair all cracks and defective rendering etc before painting. Allow ample time for drying. Remove all moss and mould growths. Remove poorly adhering or powdery coatings.
FINISHING
Stir and mix the paint to smooth consistency. Add upto 60% water to Gobi's Protector Emulsion and apply two to three coats. Apply by brush or roller. When applying by brush, load the brush generously, apply a full even coat and do not brush out too far. When applying by roller, stir the paint to a smooth consistency before pouring into the roller tray and apply freely over the surface. Clean equipment immediately after use with detergent solution / soap water.
How To Apply
NEW SURFACES
Apply a sealing coat of Gobi's wall sealer. Make good all surface roughness and imperfections with Gobi's Sona wall putty. Allow the putty to dry over night before sanding and finishing with Gobi's Protector Emulsion.
OLD SURFACE
Apply a sealing coat of Gobi's wall sealer and allow it to dry over night. Make good all surface roughness and imperfections with Gobi's Sona wall putty before finishing with Gobi's Protector Emulsion.
FINISHING
When applying by brush, load the brush generously, apply a full even coat. Avoid applying very thick coat. When applying by roller stir the paint to a smooth consistency before pouring into the roller tray and apply freely over the surface. Gobi's Protector Emulsion. is a unique paint with an extra ordinary spreading power, so do not hesitate in stretching it over.