Total item
Cart Subtotal
Rs 0.00 Details
Description
Top quality water borne emulsion paint which dries to a fresh smelling smooth finish. It provides pleasing uniformity of color and due to low reflectance, it hides surface imperfection.
Recommended Usage
It is suitable for all interior masonry, concrete, plaster and brick surfaces. It can also be applied on wall board and wood surfaces.
COMPOSITION
Based on copolymer emulsion binder and light fast pigments.
ODOR
Odorless/VOC free
FLASHING POINT
Not applicable.
MIXING RATIO
Single pack ready to use after thinning 30-40 % with water.
FILM THICKNESS
25-30 microns per coat
COLOR
Wide range available,see shade card.
COVERAGE CAPACITY
16-18 m2 per liter per coat on non-porous surfaces
FINISH
High Gloss
GLOSS
Matt
SPECIFIC GRAVITY
1.53-154 g/L
NUMBER OF COATS
Two to Three coats depend upon the surface.
PACK SIZE
1, 4 & 16 liters
NON-VOLATILE MATTER
60-62 %
DRYING TIME
Surface Dry 30Min.Recoat able 2hours
VISCOSITY
18P-22P (Poise)
APPLICATION
Brush & Roller or conventional Spray
VOLUME SOLIDS
39-43 %
THINNER
Water
Pre Painting Steps
NEW SURFACES
Ensure that the surface is thoroughly dry. Allow all the efflorescent salts to diffuse to the surface until white residue does not appear on the surface. Remove all loose powder by sweeping with brush using a rubbing stone and sand paper.
OLD SURFACE
Thoroughly clean the surface and remove old loose paint. If the surface has been previously with “oil bound” distemper, white wash or any other powdery coating it should be completely scraped.
FINISHING
Stir and mix the paint to smooth consistency
How To Apply
NEW SURFACES
Apply a sealing coat of Gobi’s Aqueous wall sealer. Allow it to dry overnight. Interior surfaces should be filled with Gobi’s Sona wall putty to achieve a smooth surface.
OLD SURFACE
Apply a sealing coat of Gobi’s aqueous wall sealer and allow it to dry overnight. Interior surfaces should be filled with Gobi’s Sona wall putty to ensure a smooth and uniform finish.
FINISHING
Add up to 30-40% water to Gobi’s Plastic Emulsion and apply two to three coats.