Details
Description
Recommended Usage
COMPOSITION
Based on special long oil alkyd resin and highly durable non-toxic lead free pigments.
MIXING RATIO
Single pack, ready to use after thinning.
COVERAGE
13-14 m2 per liter per coat on non-porous surfaces.
THINNER
Mineral Turpentine/White Spirit
FLASH POINT
34°C
PRE PAINTING STEPS
NEW WOOD
Ensure that the wood is thoroughly seasoned and moisture free. Dry scuff and smooth the surface with sand paper.
NEW STEEL
Remove all rust, loose millscale, dirt and grime by scraping and wire brushing. Wipe with solvent socked rag.
OLD WOOD
Remove all loose, flaky paint by scrapping back to a firm edge. Dry scuff and smooth the surface with sand paper. Remove all surface debris. To remove grease, wipe with solvent socked rag.
OLD STEEL
Remove all loose flaky paint by scrapping back to a firm edge. Wash down with soapy water and dry immediately. Ensure Wet scuff with mineral turpentine / white spirit and sand paper.
FINISHING
To remove surface defects and for better adhesion, use sand paper lightly between coats. Apply by brush, roller or conventional spray.
How To Apply
NEW WOOD
Apply one coat of Gobi's matt enamel and let it dry overnight. Dry scuff again, fill the surface II required and allow drying for 6 -8 hours. Do dry scuff once more.
NEW STEEL
Apply one coat of Gobi's primer and allow drying over night. Do dry scuff lightly with No 320 sand paper.
OLD WOOD
Apply one coat Gobi's matt enamel and let it dry overnight. Dry scuff again, fill the surface if required and allow drying for 6-8 hours. Do dry scuff lightly with No 320 sand paper.
OLD STEEL
Apply one coat of Gobi's primer and allow drying over night. Do dry scuff lightly with No 320 sand paper.
FINISHING
Apply 2-3 coats of Gobi's matt enamel and let it dry over night between coats.