Total item
Cart Subtotal
Rs 0.00 Details
Description
Gobi’s Aqueous Matt Finish is exceptionally tough silky finish with outstanding color retention and scratch resistance. The product is washable with good water repellency and environmental friendly.
Recommended Usage
Pre Painting Steps
ODOR
Odorless/VOC free
FILM THICKNESS
25-30 microns per coat
FLASHING POINT
>34 C
COMPOSITION
Based on special acrylic binder and highly durable pigments free from toxic metals (lead, cadmium).
WET-SCRUB RESISTANCE
More than 1000 times at wet film thickness of 100 microns. (TQC Washability Tester AB 5000)
COLOR
Wide range available, see shade card.
MIXING RATIO
Single pack, ready to use after thinning 20-30% with water.
COVERING CAPACITY
16-18 m2 per liter per coat on non-porous surfaces.
GLOSS
A subtle Silk sheen.
SPECIFIC GRAVITY
1.39-1.40 g/L
NUMBER OF COATS
Two to Three
PACK SIZE
0.91, 3.64, 14.56 Liters.
NON-VOLATILE MATTER
55±2 %
DRYING TIME
Surface Dry 1 Hour Recoat able 3-4hours
APPLICATION
Brush, Roller and Conventional Spray.
VISCOSITY
110-120 Ku (Krebs)
THINNER
Water
VOLUME SOLIDS
38-42 %
Pre Painting Steps
NEW SURFACES
Ensure that the surface is thoroughly dry. Allow all the efflorescent salts to diffuse to the surface until white residues do not appear on the surface. Remove all loose powder by sweeping with brush using a rubbing stone and sand paper.
OLD SURFACE
Thoroughly clean the surface and remove old loose paint. If the surface has been previously with “oil bound” distemper, white wash or any other powdery coating it should be completely scraped.
FINISHING
Thin paint to brushing consistency with clear water. The first coat must be applied thin by brush in order to seal the surface. Apply by brush or roller two to three coats.
How To Apply
NEW SURFACES
Apply a sealing coat of Gobi’s Wall Sealer. Make good all surface roughness and imperfections with Gobi’s Sona wall putty. Allow the putty to dry for 3-4 hrs. before finishing with Gobi’s Aqueous Matt Finish.
OLD SURFACE
Apply a sealing coat of Gobi’s Wall Sealer and allow it to dry overnight. Make good all surface roughness and imperfection with Gobi’s Sona wall putty before finishing with Gobi’s Aqueous matt finish.
FINISHING
When Applying by brush, load the brush generously, apply a full even coat. Avoid applying very thick coat. When applying by roller sir the paint to smooth consistency before pouring into the roller tray and apply freely over the surface.